Filter
Top Products
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Page 71
Add On Conference - 8 Party A-121
Programming (cont’d)
STEP 5: ASHP - When the system accommodates multiple PA-CFTB circuit cards, assign a STATION
HUNTING - TERMINATING group for the stations programmed to LEN level 0 of each PA-CFTB
circuit card. For more details, see the figure below:
STEP 6: AKYD -assignFKY83toanyD
term
s that require the use of the Retain Conference feature.
STEP 7: ADSL - Assign SN=3 (STATION BUSY) and FKY=13 (THREE-WAY CALLING;CONF).
Assign FKY=83 (RETAIN CONFERENCE; RETAIN) to any D
term
which require the use of the
RETAIN CONFERENCE feature.
This command is required for assigning the function to each soft key.
STEP 8: ARSC - assign Restriction data between routes and the RSC used by the CFTB.
STEP 9: ATNR - assign restriction data between tenants.
FCCS Programming
This data setting describes only the additional or replacement commands used to activate FCCS
services. When used as an FCCS feature, these commands replace the non-network commands (for
example, AAED is replaced by AAEDN). Note that the data setting for FCCS service varies depending
on the node. Note
STEP 1: ASYDL - This data must be assigned to the node set Add On Conference - 8 Party.
System Data 1, Index 527, bit 4 = 1
Note: When using ASYDL or ASYDN to program an FCCS feature, the basic programming of ASYD is required
in addition to ASYDL or ASYDN.
STATION HUNTING - CIRCULAR groups assigned by
ASHC command
STATION HUNTING - TERMINATING groups assigned by
ASHP command
Pilot
LV7
LV0
PA-CFTB PA-CFTB PA-CFTB