Filter
Top Products
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Page 769
Trunk Line Appearance T-23
Interactions (cont’d)
4. TRUNK LINE APPEARANCE and HOTLINE-OUTSIDE [H-9] are mutually exclusive. Both features
require the AHLS command, and the same station cannot be provided with two Hotline features.
Programming
STEP 1: ASDT - Assign the station with the TRUNK LINE APPEARANCE as a virtual line (TEC = 18).
TN: Tenant Number
STN: Station Number
LENS: Line Equipment Number (6 digits)
TEC: Telephone Class (1-31)
1: DP (10pps)
2: PB
3: DP/PB
12: D
term
13: Data Terminal Via D
term
14: Hotline
15: CAS Line
16: Data Terminal Via Data Module
18: Virtual Circuit
23: ISDN Terminal
27: Eight Conference Equipment
RSC: Route Restriction Class (0-15)
For assignment of RSC, ARSC command.
SFC: Service Feature Class (0-15)
For assignment of SFC, ASFC command.
STEP 2: ARTD - Assign the route of the TRUNK LINE APPEARANCE as a ground-start, ring-down trunk.
RT: 1
1-OSGS :2 2-ONSG :3 3-ISGS :1 4-INSG :3 5-TF :1/3
6-TCL :1 7-L/T :1 8-RLP :2 15-LSG :1 44-PRV :1
STEP 3: ATRK - Assign the LENs, Route Number, Trunk Number, and Tenant Number. Assign one or more
trunks to a specific route used to be connected as a TRUNK LINE APPEARANCE.
STEP 4: MBTK - Assign the make idle status to the trunks.
STEP 5: ASFC - Assign a Service Feature Class that allows Brokerage Hot Line (SFI = 36) to the stations to
receive TRUNK LINE APPEARANCE.
STEP 6: AHLS - Assign the following parameters for the station with the TRUNK LINE APPEARANCE:
HOT TN: Tenant Number.
STN: Station with the TRUNK LINE APPEARANCE.
TYPE: For TRUNK LINE APPEARANCE, assign Type 3.
CON RT: Assign the TRUNK LINE APPEARANCE Route.
TK: Assign the TRUNK LINE APPEARANCE trunk.