Filter
Top Products
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Page 1045
Voice Call - CCIS V-7
Operating Procedure (cont’d)
2. Station (a) switch hook flashes and receives special dial tone. D
term
(b) still does not answer.
3. Station (a) dial the Access Code of VOICE CALL service and sends out a signal tone to D
term
(b) via the
speaker. D
term
(b) talks with Station (a) via the speaker.
Service Conditions
1. Once a VOICE CALL is executed, the message “VOICE on multi-line set” is displayed on the called
station.
2. Call Forwarding-All Calls/-Busy Line/-Don’t Answer can be serviced by VOICE CALL.
3. VOICE CALL will terminate at the station whose My-line equals the extension called.
Programming
Setting by VOICE button
STEP 1: AKYD -AssigndatatoFeaturekey.FKY=14
STEP 2: ADSL - Assign SN=2 (Originating; RBT Connection) and FKY=14 (Voice Call; VOICE).
This command is used for assigning the function to each soft key.
STEP 3: ASFC - With respect to SFC of the stations that set Voice Call, cancel the restriction of SFI= 52.
(SFI= 52: Voice Call service)
(SFI= 93: Voice Call Restrict)
Setting by SHF + Access Code (Individual Station)
STEP 1: ASYD - System 1, Index 17, bit 0: (1)
SHF + ACC Code during RBT.
STEP 2: ANPD - Assign minimum necessary number of digits for the first number of the Access Code of Voice
Call.
STEP 3: ASPA - Assigns Access Code of Voice Call.
CI= H (Hooking), SIDA= 41, SRV= SSCA (Service Code Appendix)
NEC
STN (a)
D
term
(b)
[Node B]
[Node A]
CCIS
SPDT
SPDT
RG
N
E
C
STN (a)
D
term
(b)
[Node B]
[Node A]
Voice