Filter
Top Products
NEAX2400 IPX Feature Programming Manual
Page 394 NDA-24297, Issue 1
I-5 Inter-position Transfer
I-5 Inter-position Transfer
General Description
This feature allows Attendants to transfer calls at their ATTENDANT CONSOLE [A-3] to another Attendant's
Console in systems where MULTIPLE CONSOLE OPERATION [M-4] has been provided.
Operating Procedure
To transfer a call from Attendant Console A to Attendant Console B
1. Press the START key.
2. Attendant A dials Attendant Console B identification number, or “0” for all Attendants.
3. The call is indicated at Attendant Console B or all Attendant Consoles.
4. Attendant B presses the ANSWER key or TF ICI key.
5. Attendant A presses the RELEASE key to transfer, or may consult first, then release.
Service Conditions
1. A designated identification number is assigned to each ATTENDANT CONSOLE [A-3] for the purpose
of INDIVIDUAL ATTENDANT ACCESS [I-6].
2. This feature can be provided on a TENANT SERVICE [T-12] basis.
3. An Attendant can receive one INTER-POSITION TRANSFER call at a time. An INCOMING CALL
IDENTIFICATION (TF ICI) [I-2] key can be designated for receipt of these calls.
4. An Attendant cannot transfer a conference connection to another Attendant.
5. An Attendant can extend an inter-position transferred call to any other destination.
6. NIGHT CONNECTION - FIXED/FLEXIBLE [N-1, 2]: When Night Service is active, an Attendant
position call to another Attendant cannot be answered by the night service arrangements. The calling
Attendant hears reorder tone.
7. When the operator call code is dialed, the call is routed to the predetermined Attendant Console designated
in system data for the FCCS network.
8. When assigning Function Code (FUNC) to KYN 1 of an Attendant Console by AAKP, this feature cannot
be used.
Interactions
The ASAT number may not be programmed in place of a telephone number in the ASID and ASGD commands. See
OFF-HOOK ALARM [O-6], ATTENDANT NIGHT TRANSFER [A-19], and PRIORITY CALL [P-9].
Programming
STEP 1: ASYD - System Data 2, Index 6, Bit 5. Enable INTER-POSITION TRANSFER? 0/1: No/Yes. Assign
data 1. Assigned on a per-tenant basis.
System Data 2, Index 9, Bit 3. Is INTERPOSITION TRANSFER considered an incoming call to the
Attendant Console and to be counted as a Call Waiting? 0/1: No/Yes. See CALL WAITING LAMP
[C-17].Assignedonaper-tenantbasis.
STEP 2: ASAT - Assign a specific Attendant number to each Attendant Console.
STEP 3: ATNR - Allow station-to-station connection on an Intra and Inter-tenant basis.