Filter
Top Products
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Page 879
CCIS Networking via IP C-163
Programming
STEP 1: Referring to the NEAX2400 IPX No. 7 CCIS System Manual, assign the entire basic data (such as
ASYD, ARTD, ATRK, ADPC, ACSC, ACIC1, ACIC2, MBTK, etc.) necessary for the establishment
of a CCIS Tie Line.
Enter IPTRK = 1 for both D-channel and B-channel routes on the ARTI command.
For the port assignment (B-ch) of the IPTRK card, see the IPTRK Circuit Card System Manual.
The CCIS signal controlling channel is determined in accordance with the CIC numbers of speech
channel. To provide multiple interfaces which vary from a single point code (taking CCIS and CCIS
network via IP services together within one network), CIC numbers and CICG (CIC Group) must be
assigned on the same interface. For further information, see the IPTRK Circuit Card System Manual.
STEP 2: AGIP - Assign the IP addresses of IPTRK card and connected router.
Kind: IPTRK (CCIS)
IPTEN: Assign the 1st LEN of IPTRK accommodated HW block
IPTK_IP: Assign IP address of the IPTRK card
DG_IP: Assign IP address of the router
ARP: Select DIX
CLINK_NUM: Default value
SLINK_NUM: Default value
NETMSK: Assign IP address of the Net Mask
MULT: Select Point-to-Point
DST_IP: Assign IP address of the Destination Node IPTRK card
QoS1: 0-7
QoS2: 0-7
NETID: 0-15
For further information, see the NEAX2400 IPX IPTRK Circuit Card System Manual.