Filter
Top Products
NEAX2400 IPX Feature Programming Manual
Page 90 NDA-24297, Issue 1
B-6 Brokerage - Hotline
Programming (cont’d)
STEP 3: AKYD -AssigntoaD
term
a line appearance of the Hotline station number.
TN: 1
STN: Station Number
TP: Type of D
term
(0/1)
KYN: Key Number (1-40)
KYI: Service Index
0: Key not used
1: Feature Key
2: Multi-line Key
KD: 0
TN, STN: Tenant Number and Station Number of Multi-line (Virtual)
RG: Ringing Assignment per Multi-Line Appearance
0: No Ringing
1: Ringing in Day Mode Only
2: Ringing in Night Mode Only
3: Ringing Day and Night
FCCS Programming
This data setting describes only the additional or replacement commands used to activate FCCS
services. When used as an FCCS feature, these commands replace the non-network commands (for
example, AAED is replaced by AAEDN). Note that the data setting for FCCS service varies depending
on the node.
AHLSN - This data must be assigned to the NCN.
UGN: User Group Number
TELN: Telephone Number of the calling party
TYPE: 1 (the called party is a station)
CON UGN:User Group Number of the called party
CON TELN:Telephone Number of the called party
Note: The current data should also be set in addition to the command above.
The command to be set to the node accommodating the calling party: ASDT/AKYD
The following ASFC command data must be assigned at all nodes to be set BROKERAGE HOTLINE
service. SFI=36 (Brokerage Hotline), RES=1 (allowed)
Single Line
TEC: 14
Assign as STN and
CON STN in AHLS
N
E
C
D
term
Assign Subline as
Virtual: TEC 18
Assign as STN and
CON STN in AHLS
Hotline