Filter
Top Products
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Page 173
Call Waiting - Terminating C-12
Service Conditions (cont’d)
9. CALL WAITING - TERMINATING cannot be used in conjunction with DIAL ACCESS TO
ATTENDANT [D-2].
10. CALL WAITING - TERMINATING cannot be activated if the target station has accessed, entered, or is
engaged in any of the following features or modes:
ATTENDANT CAMP-ON WITH TONE INDICATION [A-1]
ATTENDANT OVERRIDE [A-7]
BOSS - SECRETARY OVERRIDE - D
term
[B-5D]
BUSY VERIFICATION [B-3]
CALL BACK [C-1]
CALL HOLD [C-6, C-6D]
CALL TRANSFER [C-10, C-11, C-11D]
CALL WAITING - ORIGINATING [C-31]
CONSULTATION HOLD - ALL CALLS [C-17, C-17D]
DATA LINE SECURITY [D-12]
DATA PRIVACY ON DEMAND [D-17]
DIAL ACCESS TO ATTENDANT [D-2]
EXCLUSIVE HOLD - D
term
[E-4D]
EXECUTIVE RIGHT-OF-WAY [E-1]
LINE LOCKOUT [L-3]
NON - EXCLUSIVE HOLD - D
term
[N-7D]
OUTGOING TRUNK QUEUING [O-2, O-2D]
PRIVACY - D
term
[P-14D]
PRIVACY RELEASE [P-18]
THREE-WAY CALLING [T-2, T-2D]
VOICE CALL - D
term
[V-2D]
11. The following service features take precedence over CALL WAITING - TERMINATING:
CALL FORWARDING - ALL CALLS [C-5]
CALL FORWARDING - BUSY LINE [C-3]
STATION HUNTING - CIRCULAR [S-7]
STATION HUNTING - SECRETARIAL [S-8]
STATION HUNTING - TERMINAL [S-9]
Interactions
1. This feature is allowed whenever the destination telephone set is in any state other than:
a.) Engaged in three-way connection,
b.) A PRIVACY feature is activated,
c.) Connected to a route programmed to have Line/Trunk, Privacy, CDN 44:PRV,
d.) Listening to a tone (dial tone, reorder tone, service set tone, busy tone, ringback tone).
e.) Connected to the Attendant Console.
2. To answer a CALL WAITING-TERMINATING call, System Data 2, Index 1, Bits 0 & 1,
CONSULTATION HOLD [C-17]; assign data “11” to allow CONSULTATION HOLD.
3. To answer a CALL WAITING - TERMINATING call from a D
term
, press the ANSWER key. The
answering party can alternate between the calls by pressing the ANSWER key.
4. Enabling ATTENDANT LOOP RELEASE [A-6] (System Data 2, Index 6, Bit 7), a call Camped-On to a
station via the Attendant Console will wait at that station for the time set in Index 145. When the preset
time has elapsed, the call will return to the Attendant Console.