Filter
Top Products
NEAX2400 IPX Feature Programming Manual
Page 652 NDA-24297, Issue 1
S-7 Station Hunting - Circular
Service Conditions (cont’d)
16. This feature will be activated whenever the hunt group is dialed or terminated under the following
conditions:
a.) dialed from a station
b.) dialed from ATTENDANT CONSOLE [A-3]
c.) dialed from DID [D-8]
d.) dialed from TIE LINE [T-3]
e.) terminatedbyDIT[D-7]
f.) terminated by HOT LINE [H-1]
g.) terminated by OFF-HOOK ALARM [O-6]
h.) terminated by PRIORITY CALL [P-9]
17. An ISDN terminal cannot hunt a call.
18. A station within a Circular Hunt Group may deny hunting function for an incoming call originated from
a station (including PS and ATT). Service Condition are as follows:
a.) Incoming trunk call (including C.O./ISDN line) is not available.
b.) When CALL FORWARDING - DON’T ANSWER or CALL FORWARDING - BUSY LINE is
set to a station within Circular Hunt Group, a call to the pilot station is forwarded according to
their service condition.
c.) Assign ASYD System Data 1, Index 439, bit 7=1, and allow SFI 181 of a station which denies
hunting function.
19. A telephone number is allowable for the station assignment of this feature activated via FCCS link.
20. The station that has been assigned as the pilot station of a Hunt group-Terminal, a UCD controlling station,
or a station of Circular Hunt Group cannot be assigned as a member of the other Circular Hunt Group.
21. All calls terminated to a Circular Hunt station are hunted when encountering a busy station.
22. When using the FCH card:
a.) Stations in four different nodes can be assigned to a Circular Hunt Group.