Filter
Top Products
NEAX2400 IPX Feature Programming Manual
Page 346 NDA-24297, Issue 1
E-26 Expanded Multiple Line Operation - D
term
Service Conditions (cont’d)
b.) PA-16ELCJB-B, SW10, Element 1 = OFF:A D
term
, accommodated on this card, and the other
Lines (other analog telephone/D
term
)canbein
different IMGs (but in the same node). For more
details on the PA-16ELCJ-B circuit card, refer to the
NEAX2400 IPX Circuit Card Manual.
Note: Even when Element 1 of SW10 is ON, data programming for this feature (Multiple Lines beyond different
IMGs) is possible. However, the data does not become effective until the switch is manually placed to OFF.
3. A D
term
cannot register a Sub Line accommodated on an ELC card in a different node (having a different
CPU). Therefore, if your system is an IPX-U (16-IMG) type, this feature must be programmed on a node
basis.
4. Three kinds of lines can appear on a D
term
line/feature key:
• MY Line (ML):This line is associated with the extension number assigned to the port on the interface
circuit.
• Prime Line (PL):This line is given priority for outgoing and incoming calls. The prime line is
automatically seized when going off-hook.
• Sub Line (SL):This line designates any other line appearing on a D
term
. The MY Line will serve as a
prime line, unless differentiated in system data programming.
5. A maximum of 32 PA-16ELCJB-B cards (a total of 512 ports) can be used for this feature (Multiple Lines
beyond different IMGs), per node.
Note: This is not the case if the Multiple Lines are programmed in a single IMG.
6. If the system is a 1-IMG type, this feature is not available.
7. A virtual line (Software Line Appearance [S-33]), single line telephone or D
term
can be assigned as a
subline.
8. To use this feature, flag “1” to the ASYD command, SYS 1, Index 321, b0.
9. When KD = 1 (Intercom) or KD = 2(DSS Key) is assigned on the AKYD command, this service is not
available. Be sure to assign KD = 0 (Line).
Interactions
1. This feature is effective with the following services:
Call Hold [C-6, 6D]
Call Forwarding - Busy Line [C-2, 2D]
Call Forwarding - Don’t Answer [C-3, 3D]
Call Forwarding - All Call [C-5, 5D]
Voice Call [V-2]
Call Pick Up - Group [C-7, 7D]
Boss - Secretary Override - D
term
[B-5D] Note
Boss - Secretary - Message Lamp Control [B-8] Note
Boss - Secretary Transfer [B-11] Note
Station Hunting - Circular [S-7]
Station Hunting - Secretarial [S-8]
Station Hunting - Terminal [S-9]
Three Way Calling [T-2, 2D]
Call Transfer [C-11, 11D]
Consultation Hold - All Calls [C-17, 17D]
Blind Transfer To Attendant [B-17]
Blind Transfer To Station [B-18]