Filter
Top Products
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Page 1033
Toll Restriction - 3/6-Digit - CCIS T-26
Programming (cont’d)
OGRT: Outgoing Route Number
DC: Destination (Area) Code (Maximum 11 digits)
TDI: Restriction Data*
0: Connection is Restricted
1: Connection is Allowed
2: 3/6-Digit Toll Restriction [Go to AARP]
3: C.O. Operator Call 9 + 0.
NND: Number of Necessary Digits (Used only when TDI = 2).
Note: TDI 4 may appear when the digits input under the DC parameter are incorrect. The switch is looking for
more digits.
STEP 5: AARP - This command is used to designate digits translated for 3 and 6-digit restriction. In ATDP, a
digit code is listed. The system will examine these digits and if the Restriction Code (TDI) is assigned
as data “2,” Toll Restriction, the program will do two operations. The first is to examine the NND
value. If NND is “6,” then the AARP information will apply to the sixth digit dialed. For example,
assume 9-1-301-555-1212 is dialed. AARP will look at the sixth digit dialed for translation.
Translation will begin with 555.
Assign the following:
OGRT: Outgoing Route Number
RSC: Route Restriction Class
FLAG: 1: 3 Digits
2: 6 Digits
DC: 555
RES: Restriction Data
0: Restricted
1: Allowed
Note: Only 3 digits or 6 digits may be entered for the DC parameter of this command.
Examples Of Toll Restriction
Listed below are several examples of the use of TOLL RESTRICTION. For these examples refer to
the following sample user requirements:
RSC 1: Allowed local only.
RSC 2: Allowed local plus Area Codes 718, 212, 201, & 914
RSC 3: Allowed local plus Area Codes 718, 212, 201, & office codes 239, 465 & 798 only within the
914 Area Code.
RSC 4: Allowed local plus all Area Codes except 808, 213, 408, 714.
RSC 5: Allowed local plus all Area Codes but restricted from 976 within each Area Code.
To simplify the examples, only one route, (route 1, DDD) will be used. There will be no difference
between day and night restrictions. 1 + dialing is assumed with an LCR access code of 9.
Example 1 - RSC 1 Assignment
ATDP Command -
TDM/OG: O (Outgoing Connection)
DAY/NIGHT: D (Day)
OGRT: 1 RSC: 1
DC: 92 TDI: 1 (Connection is Allowed)
Repeat these same assignments for Digit Codes (DC) 93 - 99 to allow all local office codes.