Filter
Top Products
NEAX2400 IPX Feature Programming Manual
Page 706 NDA-24297, Issue 1
S-27 Service Feature Peg Count
Service Conditions (cont’d)
17. SPEED CALLING ACCESS-GROUP [S-23] count: Number of times a variable abbreviated number is
registered by stations for which the feature is allowed.
18. TRUNK ANSWER FROM ANY STATION (TAS) [T-8] count: Number of times the TAS Answer code
is dialed by stations for which the feature is allowed.
19. OFF-HOOK QUEUING [O-7] count: Number of times an extension accesses an outgoing trunk via OFF-
HOOK QUEUING after initially encountering a condition where all outgoing trunks are busy. The
extension must actually access a trunk in order for the count to be incremented.
20. ON-HOOK OUTGOING QUEUING-ENTRY [O-2] count: Number of times an extension accesses the
ON-HOOK OUTGOING QUEUING feature by dialing access or going on-hook (if automatic queuing is
provided) after initially encountering a condition where all outgoing trunks are busy. The count will be
incremented each time the feature is accessed, even if the queuing request is cancelled before a trunk is
accessed.
21. ON-HOOK OUTGOING QUEUING [O-2] cancel count: Number of times ON-HOOK QUEUING is
cancelled by dialing the cancel code.
22. CONSULTATION HOLD-ALL CALLS [C-17] count: Number of times CONSULTATION HOLD is
executed.
23. CALL TRANSFER-ALL CALLS [C-11] count: Number of times a call is transferred to another extension
before the called party answers, without Attendant involvement. A call originated internally or from the
outside will be registered in the count.
24. THREE-WAY CALLING [T-2] count: Number of times THREE-WAY CALLING occurs without
Attendant assistance.
25. The maximum Tenant Number Counting SERVICE FEATURE PEG COUNT is 63 tenants.
Note: Additional hardware is required.
Programming
STEP 1: ASYD - System Data 1, Index 47, Bit 7. Are traffic measurements required? 0/1: No/Yes.
Refer to the following commands to order PEG COUNTS
STEP 2: ATRF - Assignment of Traffic Measurement Order (CM03)
TYPE: Type of Traffic Measurement
PORT: Port number where Traffic Data is to be output.
INTERVAL: Output Interval must be assigned in units of 10 minutes (range of between 30-120
minutes), or data “0” must be assigned, which is the instruction for assigning output
time.
FROM-TO-: Measurement is to be designated.
TIME: Output Time
TYPE:
1: Terminal Traffic Measurement
2: Route Traffic Measurement
3: Station Peg Count
4: Attendant Console Peg Count
5: Route Peg Count
6: Service Peg Count
8: UCD Route Peg Count
9: UCD Group Peg Count