Filter
Top Products
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Page 19
Announcement Service A-15
Programming (cont’d)
STEP 3: ARTD - Assign the announcement route as shown below. Be sure to provide privacy by programming
CDN 44:PRV as data “1”.
RT: 1
1-OSGS :2 2-ONSG :3 5-TF :1 6-TCL :1 7-L/T :1
8-RLP :2 15-LSG :4
STEP 4: ARSC - Assign a Route Restriction Class (RSC) to the station that allows access to the Announcement
route. Assign RSC 0 to the Attendant, and allow that RSC access to the Announcement route.
STEP 5: ATRK - Assign the LEN Number, Announcement Trunk Route Number. Assign one or more trunks to
a specific route used to connect to an announcement machine.
STEP 6: MBTK - Assign the Make Idle status to the announcement trunk.
STEP 7: ARRC - If TIE Line, DID, or REMOTE ACCESS TO PBX [R-2] connection to the Announcement
Service trunk is required, allow trunk-to-trunk connection using ARI-D-RES=1 (Direct Connection is
allowed.)
STEP 8: AAED - This command is used to assign announcement equipment.
Dead Level:
Assign:
TN: Tenant Number
EQP: (Announcement Equipment Number) = 0 (Dead Level). For example, level 8 is not assigned
an announcement is returned rather than a reorder tone.
RT, TK:Route and Trunk number of the trunk connected to the announcement equipment.
Unused Number:
Assign:
TN: Tenant Number
EQP: 1 (Unused Number). For example: EXT-7836 is not in the system. An Announcement is
returned rather than a reorder tone.
RT, TK:Route and Trunk number of the trunk connected to the announcement equipment.
Announcement Service:
Assign:
TN: Tenant Number
EQP: = 2 - 15
RT, TK:Route and Trunk number of the trunk connected to the announcement equipment.
C: Duration of Connection, 0/1:Disconnection occurs in 30 seconds / Connection is held until the
station releases. See the requirements of the application for the announcement equipment. For
Dead Level applications, data 0 is assigned.
R: Sending RBT 0/1: sending RBT/not sending RBT.
A: Answer Signal Sending, 0/1: no answer from Incoming trunk/Answer from Incoming trunk.
Normally assign data “1”.
M: Multiple Connection 0/1: Single Connection/Multiple Connection. Usually assign for single
connection.