Filter
Top Products
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Page 267
Consultation Hold Release C-169
General Description (cont’d)
Operating Procedure
See General Description.
Service Conditions
1. This feature is available when System Data 1 Index 803 Bit 1 = 1 is assigned.
2. When there is a call terminated at Chinese specification MFC trunk in calls related to this feature, this
feature is not available.
3. ISDN terminal equipment cannot be applied to operating station of this feature.
After station B presses
DISC key
MUX
Station A
Station B
Station C
ELC
CFTB
card
MUX
Station A
Station B
Station C
(ROT)
ELC
CFTB
card
After station B goes
switch hook flash
MUX
Station A
(HOLD)
Station B
Station C
LC LC
CFTB
card
MUX
Station A
Station B
Station C
(ROT)
CFTB
card
Procedure for D
term
Situation 3: When Station B is talking
with Station C after Station
B holds (Consultation Hold -
All Calls - D
term
[C-17])
Station A while Station A
and B in a conference (Add-
On Conference - 8 Party [A-
121]). PS/ISDN terminal
equipment cannot be
applied to this feature.
• Station A: Original Call (conference
member)
• Station B: Operating station for this
feature (conference
member)
• Station C: Second call, which is not
conference member, called
by Station B (it can be
disconnected by this
feature)
Procedure for Analog Station
Note 1: This feature is not available when operation station (Station B) is in
Add-On Conference - 8 Party [A-121] while holding Station C
(Station/Trunk) using TRANSFER key.
Note 2: Only when System Data 1 Index 803 bit 2 = 1 is assigned, Station C
can be disconnected.
Note 3: When ASFC command SFI 131 = 1 (Add-On Conference - 8 Party)
is assigned to Station B, Station C is called in to Add-On Conference
- 8 Party [A-121].