Filter
Top Products
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Page 283
Direct Outward Dialing (DOD) D-9
Programming
STEP 1: ASYD - System Data 1, Index 65. Assign the number of routes in the system.
STEP 2: ANPD - Reserve a number level for outgoing trunk access. Assign for Normal (N) and Hooking (H).
Assign NND in accordance with a predetermined numbering scheme.
STEP 3: ASPA - Assign the access code as assigned in ANPD above. Type of Service, SRV = OGC (Outgoing
Call) Outgoing Trunk. Assign the route number associated with the access code.
STEP 4: ARTD - Assign the DOD route as shown below:
GROUND START:
RT: 1
1-OSGS :2 2-ONSG :3 5-TF :1 6-TCL :1 7-L/T :1
8-RLP :2 15-LSG :1
LOOP START:
RT:1
1-OSGS :2 2-ONSG :3 5-TF :1 6-TCL :1 7-L/T :1
8-RLP :2
STEP 5: ATRK - Assign the LENs, DOD Trunk Route Number), Trunk Number, and Tenant Number.
STEP 6: MBTK - Assign the Make Idle status to the DOD trunks.
STEP 7: ARSC - The Route Restriction Class must be constructed via RRI: 3, direct access, to allow the station
access to the involved routes.
FCCS Programming
This data setting describes only the additional or replacement commands used to activate FCCS
services. When used as an FCCS feature, these commands replace the non-network commands (for
example, AAED is replaced by AAEDN). Note that the data setting for FCCS service varies depending
on the node.
Note
STEP 1: ANPDL - Reserve a number level for outgoing trunk access. Assign for Normal (N) and Hooking (H).
Assign NND in accordance with a predetermined numbering scheme.
STEP 2: ASPAL - Assign the access code as assigned in ANPD above. Type of Service, SRV = OGC
(Outgoing Call) Outgoing Trunk. Assign the logical route number associated with the access code.
STEP 3: ARTDN - Assign the DOD route as shown below:
GROUND START:
RT: 1
1-OSGS :2 2-ONSG :3 5-TF :1 6-TCL :1 7-L/T :1
8-RLP :2 15-LSG :1
LOOP START:
RT:1
1-OSGS :2 2-ONSG :3 5-TF :1 6-TCL :1 7-L/T :1
8-RLP :2
STEP 4: ARSCN - The Route Restriction Class must be constructed via RRI: 3, direct access, to allow the
station access to the involved routes.
Note: When using ASYDL or ASYDN to program an FCCS feature, the basic programming of ASYD is required
in addition to ASYDL or ASYDN.