Filter
Top Products
NEAX2400 IPX Feature Programming Manual
Page 746 NDA-24297, Issue 1
T-6 Toll Denial/Toll Diversion
Programming (cont’d)
Bit 3- Develop ATDP command for Day/Night?
System Data 2, Index 1, bits 4 & 5. If TOLL DENIAL is required, assign these bits as data “00”.If
TOLL DIVERSION is required, assign these bits as “01”. Calls are then diverted to the Attendant
Console. Assigned on a per-tenant basis.
STEP 2: ARSC - Assign Route Restriction Classes. When these are assigned to stations, classes will determine
whether or not a station will be allowed access to a specific route or specific dialing sequence. See
TOLL RESTRICTION-3/6 DIGIT [T-7]. Assign the following:
DAY/NIGHT:Day/Night Mode
D: Day Mode
N: Night Mode
TN: Tenant Number
RT: Route Number
RSC: Route Restriction Class
RRI: Route Restriction Index
0: IC Restriction via Attendant Console (DDD, etc.)
1: IC Restriction Direct Connection (DID, etc.)
2: OG Restriction via Attendant Console
3: OG Restriction Direct Connection (DDD, etc.)
RES: Restriction Data
0: Connection is Restricted
1: Connection is Allowed
2: Connection is Toll Restricted (See TOLL RESTRICTION-3/6-DIGIT [T-7])
STEP 3: ASDT - When assigning the data to specific stations, assign the proper RSC to each station.
FCCS Programming
This data setting describes only the additional or replacement commands used to activate FCCS
services. When used as an FCCS feature, these commands replace the non-network commands (for
example, AAED is replaced by AAEDN). Note that the data setting for FCCS service varies depending
on the node. Note
STEP 1: ASYDL - Index 640, assign FPC of the Attendant Console for Toll Diversion
STEP 2: ARSCN - Assign Route Restriction Classes. When these are assigned to stations, classes will
determine whether or not a station will be allowed access to a specific route or specific dialing
sequence. See TOLL RESTRICTION-3/6 DIGIT [T-7]. Assign the following:
DAY/NIGHT:Day/Night Mode
D: Day Mode
N: Night Mode
TN: Tenant Number
RT: Route Number
RSC: Route Restriction Class
RRI: Route Restriction Index
0: IC Restriction via Attendant Console (DDD, etc.)
1: IC Restriction Direct Connection (DID, etc.)
2: OG Restriction via Attendant Console
3: OG Restriction Direct Connection (DDD, etc.)