Filter
Top Products
NEAX2400 IPX Feature Programming Manual
Page 102 NDA-24297, Issue 1
B-18 BlindTransferToStation
B-18 Blind Transfer To Station
General Description
This feature allows two Class Marks to be assigned to stations, enabling services such as Voice Mail, announcement
machine, etc. depending on the Class Mark.
1. A Class Mark which allows No Answer timer to be extended when the Blind Transferred-to station does
not answer within the predetermined period of time interval.
2. A Class Mark which activates CALL FORWARDING - DON'T ANSWER [C-3] set to the Blind
Transferred-to station when CALL FORWARDING - DON'T ANSWER [C-3] is available.
Operating Procedure
To transfer a call in progress
1. While connected to another party (station or trunk), the user presses switch hook or TRANSFER key on
D
term
; receives special dial tone.
2. User dials the third station; receives ringback tone. If the user remains on the line, the transferred party
hears MUSIC ON HOLD [M-7].
3. At this point, the user can hang up before the third station answers; the transferred party hears ringback
tone.
Service Conditions
1. This feature is allowed only when a station is engaged in a two party connection (station or trunk).
2. Samples of connection patterns available under BLIND TRANSFER service are as follows:
a.) Station A blind-transfers incoming trunk/station to Station B.
b.) Station A blind-transfers incoming trunk/station call to the Attendant.
c.) Station A blind-transfers incoming trunk/station call to Station B, which has set CALL
FORWARDING-DON’T ANSWER to Station C (the call is forwarded to Station C).
d.) Station A blind-transfers incoming trunk/station call to Station B, which has set CALL
FORWARDING-DON’T ANSWER trunk (the call is forwarded to outside station).
3. The Class Mark that extends No Answer timer must be the same as the one used for BLIND TRANSFER
TO ATTENDANT [B-17]. This Class Mark is assigned to the transferring station.
4. Depending on system data assignment, the following conditions occur when CALL FORWARDING -
DON'T ANSWER feature is set on the Blind Transferred-to station:
a.) the transferring station is recalled.
b.) the transferred-to station rings continuously.
c.) the call is forwarded when the CALL FORWARDING - DON'T ANSWER timer expires.
5. If the destination station for Blind Transfer has set CALL FORWARDING - DON'T ANSWER [C-3] to
a station/trunk, Call Forwarding is activated when a predetermined No Answer timer expires.
6. This feature is available for stations in the FCCS network only.