Filter
Top Products
NEAX2400 IPX Feature Programming Manual
Page 276 NDA-24297, Issue 1
D-6 Digital Display - Trunk
Service Conditions (cont’d)
d.) an outgoing C.O. (DOD, WATS, FX) type call.
e.) an outgoing TIE Line call or re-enters a held trunk call.
7. An Attendant Console also indicates the C.O. code assigned by system data at each node in the FCCS
network.
Programming
STEP 1: ASYD - System Data 1, Index 68, Bit 1. Type of INDIVIDUAL TRUNK ACCESS, 0/1: Route and
Trunk Number/Central Office Code.
Note: If System Data 1, Index 68, Bit 1 is assigned for the Individual Trunk Access to be the ACOC code, then all
of the trunks in all of the routes in the system must have the ACOC code assigned.
STEP 2: ARTD - In CND 25:R/L, if data “0” is assigned, then tenant, route number, and trunk number are
displayed. If data “1” is assigned, then Central Office code is displayed. The ACOC command must be
assigned.
Note: For display purposes only, Route and Trunk numbers and Central office codes may be used simultaneously
in the same system and are applied on a per-route basis, CDN 25:R/L.
Route and Trunk Number
STEP 3: ATRK - The route and trunk number assigned here provides the system with specific information on
types of routes and their associated trunks, LENs, number of tenants, and any CLASS OF SERVICE-
INDIVIDUAL [C-15] route restriction information.
Central Office Code
STEP 4: ACOC - Each trunk must be assigned a Central Office code.
FCCS Programming
This data setting describes only the additional or replacement commands used to activate FCCS
services. When used as an FCCS feature, these commands replace the non-network commands (for
example, AAED is replaced by AAEDN). Note that the data setting for FCCS service varies depending
on the node. Note
STEP 1: ARTDN - In CND 25:R/L, if data “0” is assigned, then tenant, route number, and trunk number are
displayed. If data “1” is assigned, then Central Office code is displayed. The ACOC command must be
assigned.
STEP 2: ACOCN - Each trunk must be assigned a Central Office code.
Note: When using ASYDL or ASYDN to program an FCCS feature, the basic programming of ASYD is required
in addition to ASYDL or ASYDN.