Filter
Top Products
NEAX2400 IPX Feature Programming Manual
Page 760 NDA-24297, Issue 1
T-9 Trunk Group Busy Lamp
Programming (cont’d)
TGBL data can be collected/transmitted from/to all LMGs by the circuit card DLMX (PA-PC94) via
DLKC circuit cards in the IPX-U. For more detailed information, see the NEAX2400 IPX Office Data
Specification and the NEAX2400 IPX Circuit Card Manual.
For the DLMX (PA-PC94) Circuit Card
STEP 1: ASYD - SYS1 Index 15, b0-3: In hexadecimal, assign how many TGBLs are to be used out of a total
of 10 lamps available (on the Attendant Console).
Assign 01 (Hex) - 0A (Hex) for 1-10 busy lamps.
STEP 2: ASYDL - SYS1 Index 804, b1.
0: TGBL information based on External Route data (ATGL command)
1: TGBL information based on Logical Route data (ATGLL command)
SYS1 Index 946: FPC of the LN where DLMX card is mounted (for IPX-U).
LP PBI No. of the LMG where DLMX card is mounted (for IPX-UMG).
STEP 3: ATRK - Assign the trunk data of DLMX.
RT: 938 (DLMX)
LENS: Assign LV7 of odd-number Group (G)
STEP 4: ATGL/ATGLL - Assign the Attendant No., TGBL No. (1-10) and associated Route No. Note that
ATGL is used when ASYDL SYS1 Index 804 b1 = 0, and ATGLL when the same data = 1.
ATN: Attendant No. (1-30)
TGN: Trunk Group No. (1-10)
RT: External Route No. (1-255: for ATGL command)
LGRT: Logical Route No. (1-899: for ATGLL command)
Note 1: When the data of ASYD, SYS1 Index 804 b1 is changed, be sure to reassign ATGL/ATGLL command data.
Note 2: When the system is an IPX-U, be sure that the following data has been assigned before entering the ATGL/
ATGLL command data:
ASYDL, SYS1 Index 640 (FPC of the node which has Attendant Consoles)
STEP 3: MBTK - Assign the Make Idle status to the trunk assigned in Step 3.