Filter
Top Products
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Page 391
Incoming Central Office Call to Tie-Line Connection I-3
FCCS Programming
This data setting describes only the additional or replacement commands used to activate FCCS
services. When used as an FCCS feature, these commands replace the non-network commands (for
example, AAED is replaced by AAEDN). Note that the data setting for FCCS service varies depending
on the node.
STEP 1: ARTDN - Assign the Central Office route as shown below:
GROUND START:
RT: 1
1-OSGS :2 2-ONSG :3 3-ISGS :1 4-INSG :3 5-TF :3
6-TCL :1 7-L/T :1 8-RLP :2 15-LSG :1
LOOP START:
RT: 1
1-OSGS :2 2-ONSG :3 3-ISGS :1 4-INSG :3 5-TF :3
6-TCL :1 7-L/T :1 8-RLP :2
Assign the TIE Line route as shown below:
2OR4WIREE+M:
RT: 1
1-OSGS :2 2-ONSG :3 3-ISGS :2 4-INSG :3 5-TF :3
6-TCL :4 7-L/T :1 8-RLP :2 15-LSG :5
STEP 2: ANPDL - Reserve a number level for trunk access. Assign Connection Indexes (CI) for Normal (N)
and Hooking (H). Number of Necessary Digits is usually 1 or 2. Busy Lamp Field is not activated.
STEP 3: ASPAL - Assign the access code as assigned in ANPD above. Type of Service, SRV = OGC
(Outgoing Call) Outgoing Trunk. Assign the logical route number associated with this access code.
STEP 4: ARSCN - For the incoming Central Office route, allow for RRI: 0, Incoming Call via the Attendant
Console (with Call Transfer). This Route Restriction Class (RSC) is to be assigned for the Attendant
Console in ATRK. (RSC 0).
For outgoing TIE Line route and for RSC 0, allow for RRI: 2 Outgoing Call via the ATTCON (with
Call Transfer). RSC 0 is to be assigned to the ATTCON in ATRK.
STEP 5: ARRCN - Assign 1 to the parameter ARI-D-RES for allowing tandem connection with an operator
assistance. Allow the Incoming Route Number (ICRT) of the incoming Central Office route to be
connected to the Outgoing Route Number (OGRT) of the Outgoing TIE Line route.