Filter
Top Products
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Page 265
Consultation Hold Release C-169
C-169 Consultation Hold Release
General Description
This feature enables a station, connecting to a second call while the station has been holding (consultation hold) an
original call (including ADD-ON CONFERENCE-8 PARTY [A-121] member), to disconnect the second call
forcibly by pressing DISC key for D
term
once/going switch hook flash for analog station/PS twice. After that, the
second call is released, and the original call is retrieved from hold. Situations available for this feature are as shown
below.
MUX
Station A
(HOLD)
Station B
Station C
MUX
Station A
Station B
Station C
(ROT)
After station B presses
DISC key
ELC
MUX
Station A
(HOLD)
Station B
Station C
MUX
Station A
Station B
Station C
(ROT)
After station B goes
switch hook flash
After station B goes
switch hook flash
LC
LC
MUX
Station A
Station B
Station C
LC
CFT
After station B presses
DISC key
MUX
Station A
Station B
Station C
(ROT)
MUX
Station A
Station B
Station C
(HOLD)
ELC ELC
CFT
When station B presses CONF key before pressing DISC key,
THREE-WAY CALLING-D
term
[T-2D] is established as shown below.
Three-Way Calling
Three-Way Calling
ELC
Procedure for D
term
Procedure for Analog Station or PS
Situation 1: When Station B is talking with
Station C while holding
(Consultation Hold) an original
call (Station A).
• Station A: Original Call
• Station B: Operating station for this
feature (D
term
/Analog Station/
PS)
• Station C: Second call called by Station
B (it can be disconnected by
this feature)
Note: If a trunk for Three-Way
Calling within a MUX Card
is busy, this feature is not
available.