Filter
Top Products
NEAX2400 IPX Feature Programming Manual
Page 708 NDA-24297, Issue 1
S-33 Software Line Appearance
S-33 Software Line Appearance
General Description
This feature permits ports that do not physically exist to be used as sub-lines on D
term
stations. Ports normally
reserved on a D
term
for data stations only, can be assigned as a SOFTWARE LINE APPEARANCE. Additionally,
64 software ports have been added to a Port Interface Module. The 64 software-assigned ports can be assigned as
virtual line appearances on D
term
stations. The use of the data ports and the 64 software-assigned ports conserve
valuable hardware for stations and trunks.
Operating Procedure
Call Origination via a SOFTWARE LINE APPEARANCE on a D
term
1. Press the Software Line Appearance key, then either press the SPEAKER key or lift the handset.
2. Upon hearing dial tone, dial the desired number.
Calling a SOFTWARE LINE APPEARANCE from a station/trunk/Attendant Console
1. The calling party dials the telephone number of the SOFTWARE LINE APPEARANCE.
2. Any D
term
accommodating the SOFTWARE LINE APPEARANCE will receive ringing and have an
incoming lamp display. The D
term
user presses the LINE key and goes off-hook to answer the incoming
call.
Service Conditions
1. When using a SOFTWARE LINE APPEARANCE assigned to a data port (TEC:12), call origination from
that line appearance can be made if the card is mounted in that slot.
2. A mix of data ports and sub-lines can be assigned on a D
term
package.
3. All sub-lines of D
term
s must be located in the same Local Processor as the MY-Line of that D
term
.
4. A SOFTWARE LINE APPEARANCE cannot be assigned as a Hotline Station, but can be assigned as a
BROKERAGE HOTLINE [B-12] station.
5. A SOFTWARE LINE APPEARANCE cannot activate:
CALL BACK [C-1]
OUTGOING TRUNK QUEUING [O-2]
NAILED-DOWN CONNECTION [N-9]
6. When activating CALL PICKUP-GROUP [C-7], the sub-line will pick up calls assigned to the CALL
PICKUP-GROUP of the MY-Line of the D
term
on which the sub-line appears.
7. When accessing or entering SPEED CALLING [S-2] group/station data, a SOFTWARE LINE
APPEARANCE will enter or access the SPEED CALLING [S-2] group/station data of the MY-Line of
the D
term
on which the sub-line appears.
8. The STATION MESSAGE DETAIL RECORDING (SMDR) [S-10] of the SOFTWARE LINE
APPEARANCE call activity will be recorded as the MY-Line call activity.
9. The SOFTWARE LINE APPEARANCE cannot be the called station of the following features:
VOICE CALL [V-2D]
MESSAGE REMINDER [M-22D]
BOSS-SECRETARY OVERRIDE [B-5]
10. Station PEG COUNT [P-7] data will be recorded for SOFTWARE LINE APPEARANCEs as a MY-Line
of the D
term
.
11. If the DO NOT DISTURB - D
term
[D-11D] key is activated by the SOFTWARE LINE APPEARANCE,
ringing will not be sent to the port of the MY-Line of the D
term
.