Filter
Top Products
NEAX2400 IPX Feature Programming Manual
Page 14 NDA-24297, Issue 1
A-7 Attendant Override
Interactions (cont’d)
4. CALL FORWARDING - ALL CALLS [C-5], BUSY [C-2] or DON’T ANSWER [C-3]: If an Attendant
attempts to busy verify an idle or busy station line that has activated the Call Forwarding feature, busy
verification of the destination station will occur. If an Attendant attempts to busy verify an idle or busy
station which is call forwarded to the Attendant Console, ATTENDANT OVERRIDE will not be allowed.
5. DICTATION ACCESS [D-3]: ATTENDANT OVERRIDE will be denied towards the Dictation Access
trunks.
6. PAGING ACCESS [P-1]: ATTENDANT OVERRIDE is denied to the Paging Access trunks.
7. DATA PRIVACY - CCIS [D-67] [D-68]: To prevent interruption of data transmission, the Attendant
cannot override a trunk connected to a busy station line when the user activates this feature.
Programming
STEP 1: ASYD - System Data 1, Index 78, Bit 0 & 1.
System Data 1, Index 60, Bit 5. Is the two-burst Warning Tone to be disabled? No/Yes.
System Data 1, Index 68, Bit 4. Trunk select (TKSL) key must be enabled. Assign data “1.”
System Data 2, Index 0, Bit 3, assign as data “1.”
System Data 1, Index 158, timer between tones.
STEP 2: ATRK - Assign the LEN as Route 909, Digital Conference Trunk. LEN # consists of the following:
Group and Level numbers for the Digital Conference Trunk are 210, 213, 216, 221, 224, 227, 232 and
235.
STEP 3: ASFC - For stations susceptible to ATTENDANT OVERRIDE, assign a Class of Service that allows
SFI 4, EXECUTIVE RIGHT-OF-WAY [E-1], and SFI 11, ATTENDANT CAMP-ON WITH TONE
INDICATION [A-1].
STEP 4: ARTD - When a station is connected to a trunk, CDN 44:PRV of the route must be assigned as data
“0” for ATTENDANT OVERRIDE to be allowed.
FCCS Programming
No unique programming is required for the FCCS network.
XX X XX X
Local Processor Unit Group Level