Filter
Top Products
NEAX2400 IPX Feature Programming Manual
Page 176 NDA-24297, Issue 1
C-13 Call Waiting Lamp
Programming
STEP 1: ASYD - System Data 1, Index 64, Bits 1 & 2. When will the number of calls waiting appear on the
Attendant Console? 00: When Position Available Lamp is on (Attendant Console is not actively
processing a call); 01: When BUSY LAMP FIELD is off; 10: Continuously.
System Data 2, Indexes 8 & 9. These bits flag types of incoming calls to the Attendant Console to be
counted as calls waiting. This is assigned on a per-tenant basis.
Index 8:
Bit 0 - Is an LDN call counted as a call waiting? 0/1: No/Yes.
Bit 1 - Is an incoming station call counted as a call waiting? 0/1: No/Yes.
Bit 2 - Is an Attendant Console Recall counted as a call waiting? 0/1: No/Yes.
Bit 3 - Is an FX call counted as a call waiting? 0/1: No/Yes.
Bit 4 - Is a WATS call counted as a call waiting? 0/1: No/Yes.
Bit 5 - Is a CCSA (DID) call counted as a call waiting? 0/1: No/Yes.
Bit 6 - Is a TIE Line call counted as a call waiting? 0/1: No/Yes.
Bit 7 - Is a CALL FORWARDING-BUSY LINE [C-2] call counted as a call waiting? 0/1: No/Yes.
Index 9:
Bit 0 - Is a CALL FORWARDING-DON’T ANSWER [C-3] call counted as a call waiting? 0/1: No/
Yes.
Bit 1 - Is a CALL FORWARDING - INTERCEPT [C-25, 25D] call counted as a call waiting? 0/1: No/
Yes.
Bit 2 - Will this key (type of call is assigned in AAKP) be counted as a call waiting? 0/1: No/Yes.
Bit 3 - Is an INTERPOSITION TRANSFER [I-5] call counted as a call waiting? 0/1: No/Yes.
Note: The types of calls listed above are the default types of incoming calls. System Data 2, Index 8, Bits 6 - 7, and
Index 9, Bits 0 - 3 only turn ON or OFF the ability to count an incoming call to a specific key as a call
waiting. A different type of incoming call may be assigned via AAKP.
System Data 2, Index 14, Bits 0 - 3. When CALL WAITING value exceeds a threshold value, the Call
Waiting lamp will flash.
System Data 2, Index 14, Bit 4. Will CALL WAITING-INDICATION flash for all calls? 0/1: All
calls/Pegged calls.
Note: This data is required only when assigning “X” number of calls waiting.
STEP 2: ARTD - Flag the type of route in CDN 6:TCL, Trunk Class.
STEP 3: AAKP - This command may be used to change the meaning of the top six Call Identification keys of
the Attendant Console. (See System Data 2, Indexes 8 & 9). The following functions may be assigned
to L1 - L6:
Function:
(1) CAS
(2) Off-Hook Alarm
(3) Priority Call 1
(4) Priority Call 2
(5) Priority Call 3