Filter
Top Products
NEAX2400 IPX Feature Programming Manual
Page 916 NDA-24297, Issue 1
E-20 E911 - ANI Unified Number of Digits - CCIS
Service Conditions (cont’d)
• If OG call is from an ATTCON and Individual ATT Access Code is assigned, and also ANI
data is assigned:
KP-0-N**-****-ST
• If OG call is from an ATTCON and Individual ATT Access Code is unassigned, and ANI data
is assigned:
KP-0
-N**-****-ST
• If OG call is from an ATTCON and ANI data is unassigned:
KP-1-ST
b.) Outgoing call from station/Attendant Console of Remote office, and call termination via CCIS of
Main office.
• If OG call is from a station and ANI data is assigned:
KP-0
-N**-****-ST
• If OG call is from a station and ANI data is unassigned:
KP-2
-ST
• If OG call is from an Attendant Console and ANI data is assigned:
KP-0
-N**-****-ST
• If OG call is from an Attendant Console and ANI data is unassigned:
KP-1-ST
c.) Outgoing call from station/Attendant Console of Remote office, and call termination to a TIE
Line of Main office.
KP-2
-ST
6. An independent route is required for E911 interface.
7. After caller’s number is sent out to the remote office by E911-ANI, it takes some time until a speech path
is established.
8. E911-ANI - CCIS service data are assigned only at Main office; no specific data are assigned at the remote
office.
9. Both AUTOMATIC NUMBER IDENTIFICATION (ANI) [A-78] service and E911-ANI UNIFIED
NUMBER OF DIGITS [E-18] service must have been assigned.
10. The Central Office Code (COC) consists of 1-5 digits. If office number and station number are used, the
maximum total number of digits is still 5. The Code is set in the ARNP command as RT0.
Example 1:
Office number: 82
Station number: 2xxx, 3xxx
ANI sending number
Information digit
ANI sending number
Information digit
Information digit
ANI sending number
Information digit
Information digit
ANI sending number
Information digit
Information digit
Information digit