Filter
Top Products
CHAPTER 5 Enhancing DataWindow Objects
DataWindow Designer User’s Guide 175
3 Select the Print Specifications tab.
The Print Specifications page uses the units of measure you specified on
the General page.
4 Specify print specifications for the current DataWindow object.
See Table 5-4 for more information.
Table 5-4: Setting print specifications for DataWindow objects
Setting Description
Document Name Specify a name to be used in the print queue to identify the
report.
Printer Name Specify the name of a printer to which this report should be
sent. If this box is empty, the report is sent to the default
system printer. If the specified printer cannot be found, the
report is sent to the default system printer if the Can Use
Default Printer check box is selected. If the specified
printer cannot be found and the Can Use Default Printer
check box is not selected, an error is returned.
Margins Specify top, bottom, left, and right margins. You can also
change margins in the Preview view while you are actually
looking at data. If you change margins in the Preview view,
the changes are reflected here on the Print Specifications
page.
Paper Orientation Choose one of the following:
• Default: Uses the default printer setup.
• Portrait: Prints the contents of the DataWindow object
across the width of the paper.
• Landscape: Prints the contents of the DataWindow
object across the length of the paper.
Paper Size Choose a paper size or leave blank to use the default.
Paper Source Choose a paper source or leave blank to use the default.
Prompt Before Printing Select to display the standard Print Setup dialog box each
time users make a print request.
Can Use Default
Printer
Clear this check box if a printer has been specified in the
Printer Name box and you do not want the report to be sent
to the default system printer if the specified printer cannot
be found. This box is checked by default if a printer name
is specified.
Display Buttons - Print
Preview
Select to display Button controls in Print Preview. The
default is to hide them.