11-54 SA-1100
Developer’s Manual
Peripheral Control Module
Figure 11-13. Active Mode Timing
A4793-01
L_FCLK
(VSYNC)
L_LCLK
(HSYNC)
L_BIAS
(OE)
L_PCLK
LDD[7:0],
GPIO[9:2]
Notes:
LEN - LCD enable:
0 - LCD is disabled.
1 - LCD is enabled.
VSP - Vertical sync polarity:
0 - Vertical sync clock is active high, inactive low.
1 - Vertical sync clock is active low, inactive high.
VSW - Vertical sync width:
1 to 64 horizontal sync clock periods to assert the vertical sync signal (hsync transitions).
HSW - Horizontal sync pulse width:
1 to 64 pixel clock periods to assert the line clock (pixel clock transitions).
HSP - Horizontal sync polarity:
0 - Horizontal sync clock is active high, inactive low.
1 - Horizontal sync clock is active low, inactive high.
BFW - Beginning-of-frame horizontal sync clock wait count:
0 to 255 horizontal sync clock periods to wait at the beginning of each frame (hsync transitions).
BLW - Beginning-of-line pixel clock wait count:
1 to 256 pixel clock periods to wait after line clock negated before asserting pixel clocks
(pixel clock transitions).
ELW - End-of-line pixel clock wait count:
1 to 256 pixel clock periods to wait after last pixel in line before asserting line clock (pixel clock
transitions).
PPL - Pixels per line:
1 to 1024 pixels per line on screen.
Line 1 DataLine 0 Data
PPL = 16
HSP = 0
VSP = 0
VSW = 0
BFW = 1 ELW = 1
BFW = 2 BLW = 1
HSW = 4
LEN set to 1