Filter
Top Products
SA-1100 Developer’s Manual 9-13
System Control Module
9.2.1.2 Interrupt Controller IRQ Pending Register (ICIP) and FIQ Pending
Register (ICFP)
The ICIP and the ICFP contain one flag per interrupt (32 total) that indicates an interrupt request
has been made by a unit. Inside the interrupt service routine, the ICIP and ICFP are read to
determine the interrupt source. In general, software then reads status registers within the
interrupting device to determine how to service the interrupt.
Bits within the ICPR are read only, and represent the logical OR of status bits for a given interrupt
within the source unit. Once an interrupt has been serviced, the handler clears the pending interrupt
at the source by writing a one to the necessary status bit. Clearing the interrupt status bit at the
source automatically clears the corresponding ICIP and ICFP flag provided there are no other
interrupt status bits set within the source unit.
All interrupt source status bits are cleared by writing a one to them. Writing a zero to an interrupt
status bit has no effect. The following table shows the bit locations corresponding to the 32
separate interrupt pending status flags in the ICIP. The next table shows the bit locations
corresponding to the 32 separate interrupt pending status flags in the ICFP. This is a read-only
register.
Bit31302928272625242322212019181716
Read IP31 IP30 IP29 IP28 IP27 IP26 IP25 IP24 IP23 IP22 IP21 IP20 IP19 IP18 IP17 IP16
Reset These flags reflect the OR of the reset state of the individual interrupt status bits at the source unit.
Bit1514131211109876543210
Read IP15 IP14 IP13 IP12 IP11 IP10 IP9 IP8 IP7 IP6 IP5 IP4 IP3 IP2 IP1 IP0
Reset These flags reflect the OR of the reset state of the individual interrupt status bits at the source unit.
Bit31302928272625242322212019181716
Read FP31 FP30 FP29 FP28 FP27 FP26 FP25 FP24 FP23 FP22 FP21 FP20 FP19 FP18 FP17 FP16
Reset These flags reflect the OR of the reset state of the individual interrupt status bits at the source unit.
Bit1514131211109876543210
Read FP15 FP14 FP13 FP12 FP11 FP10 FP9 FP8 FP7 FP6 FP5 FP4 FP3 FP2 FP1 FP0
Reset These flags reflect the OR of the reset state of the individual interrupt status bits at the source unit.