Filter
Top Products
SA-1100 Developer’s Manual 6-1
Caches, Write Buffer, and Read Buffer
6
To reduce effective memory access time, the Intel
®
StrongARM
®
SA-1100 Microprocessor
(SA-1100) has an instruction cache, a data cache, a write buffer, and a read buffer. All except the
read buffer are transparent to program execution. The following sections describe each of these
units and give all necessary programming information.
6.1 Instruction Cache (Icache)
The SA-1100 contains a 16 Kbyte instruction cache (Icache). The Icache has 512 lines of 32 bytes
(8 words), arranged as a 32-way set associative cache, and uses the virtual addresses generated by
the processor core. The Icache is always reloaded a line at a time (8 words). It may be enabled or
disabled via the SA-1100 control register, and is disabled on the assertion of nRESET or through a
software or sleep reset sequence. (See Section 9, “System Control Module” on page 9-1 in the
System Control Module for details.) The operation of the cache, when memory management is
enabled, is further controlled by the cacheable or C bit stored in the memory-management page
table. If memory management is disabled, all addresses are marked as cacheable (C=1). When
memory management is enabled, the C bit in each page table entry can disable caching for an area
of virtual memory.
6.1.1 Icache Operation
In the SA-1100, the instruction cache is searched regardless of the state of the C bit; only reads that
miss the cache are affected. If, on an Icache miss, the C bit is a one or the Memory Management
Unit (MMU) is disabled, a linefetch of 8 words is performed and it is placed in a cache bank with a
round-robin replacement algorithm. If, on a miss, the MMU is enabled and the C bit is a zero for
the given virtual address, an external memory access for a single word is performed and the cache
is not written.The Icache should be enabled as soon as possible after reset for best performance.
6.1.2 Icache Validity
The Icache operates with virtual addresses, so care must be taken to ensure that its contents remain
consistent with the virtual-to-physical mappings performed by the memory management unit. If the
memory mappings are changed, the Icache validity must be ensured. The Icache is not coherent
with stores to memory, so programs that write cacheable instruction locations must ensure the
Icache validity. Instruction fetches do not check the write buffer, so data must not only be pushed
out of the cache but the write buffer must also be drained.
6.1.2.1 Software Icache Flush
The entire Icache can be invalidated by writing to the SA-1100 cache operations register (register
7). The cache is flushed immediately when the register is written, but note that the following
instruction fetches may come from the cache before the register is written.