Filter
Top Products
11-120 SA-1100
Developer’s Manual
Peripheral Control Module
The following table shows the bit locations corresponding to the data field, end-of-frame bit as well
as the cyclic redundancy check and receiver overrun error bits within the HSSP data register. Note
that both FIFOs are cleared when the SA-1100 is reset, the transmit FIFO is cleared when TXE=0,
and the receive FIFO is cleared when RXE=0.
Address: 0h 8004 006C HSDR Read/Write
Bit109876543210
ROR CRE EOF Bottom of receive FIFO data
Reset00000000000
Read Access
(Note: ROR, CRE, EOF are not read, but rather transferred to corresponding status bits in the HSSP
status register 1(HSSR1) each time a new data value is transferred to HSDR).
Bit 76543210
Top of transmit FIFO data
Reset 00000000
Write Access
Bit Name Description
7..0 DATA
Top/bottom of transmit/receive FIFO data.
Read – Bottom of receive FIFO.
Write –Top of transmit FIFO.
8EOF
End of frame.
0 – The last byte of the frame has not been encountered.
1 – The data value at the bottom of the receive FIFO represents the last byte of the
frame.
Note: Each time an 11-bit value reaches the bottom of the receive FIFO, bit 8 from the
last FIFO entry is transferred to the EOF bit in HSSR1.
9 CRE
CRC error.
0 – CRC not encountered yet, or the CRC value calculated on the incoming data
matched the received CRC value.
1 – The CRC value calculated on the incoming data did not match the received CRC
value.
Note: Each time an 11-bit value reaches the bottom of the receive FIFO, bit 9 from the
last FIFO entry is transferred to the CRE bit in HSSR1.
10 ROR
Receiver overrun.
0 – No receiver overrun has been detected.
1 – Receive logic attempted to place data into receive FIFO while it was full; one or more
data values
after
the data value at the bottom of the receive FIFO were lost.
Note: Each time an 11-bit value reaches the bottom of the receive FIFO, bit 10 from the
last FIFO entry is transferred to the ROR bit in HSSR1.