Filter
Top Products
9-14 SA-1100
Developer’s Manual
System Control Module
9.2.1.3 Interrupt Controller Mask Register (ICMR)
The interrupt controller mask register (ICMR) contains one mask bit per pending interrupt bit (32
total). The mask bits control whether a pending interrupt bit will generate a processor interrupt
(IRQ or FIQ). When a pending interrupt becomes active, it is sent to the CPU only if its
corresponding ICMR mask bit is set to a one. Note that the mask bits are ignored when the
SA-1100 is in idle mode. While in idle, if any interrupt source makes a request, the corresponding
pending bit is set and the interrupt automatically becomes active, regardless of the state of its mask
bit.
Mask bits serve two purposes. First, they allow periodic software polling of interruptible sources
while preventing them from actually causing an interrupt. Second, they allow the interrupt handler
routine to prevent interrupts of lower priority from occurring while still maintaining a list of
pending interrupts that may have occurred previously (or during the servicing of another interrupt).
The ICMR is not initialized at reset; a question mark indicates that the values are unknown at reset.
The following table shows the bit locations corresponding to the 32 separate interrupt mask bits.
Bit31302928272625242322212019181716
R/W IM31 IM30 IM29 IM28 IM27 IM26 IM25 IM24 IM23 IM22 IM21 IM20 IM19 IM18 IM17 IM16
Reset????????????????
Bit1514131211109876543210
R/W IM15 IM14 IM13 IM12 IM11 IM10 IM9 IM8 IM7 IM6 IM5 IM4 IM3 IM2 IM1 IM0
Reset????????????????
Bit Name Description
{n} IM{n}
Interrupt mask n (where n = 0 through 31).
0 – Pending interrupt is masked from becoming active (interrupts not sent to CPU, Power
Manager).
1 – Pending interrupt is allowed to become active (interrupt sent to CPU, Power
Manager).
Note: IM bits are ignored during idle mode.