Filter
Top Products
Firewall Protection
151
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
IPv6 DMZ WAN Outbound Service Rules
To create a new IPv6 DMZ WAN outbound rule:
1. In the upper
right of the DMZ WAN Rules screen, select the IPv6 radio button. The screen
displays the IPv6 settings (see Figure 79 on p
age 149).
2. Click the Ad
d table button under the Outbound Services table. The Add DMZ WAN
Outbound Service screen for IPv6 displays:
Figure 81.
3. Enter the settings as explained in Table 32 on page 133. In addition to selections from the
Service, Action, and Log drop-down lists, you need to make selections from the following
drop-down
lists:
• DMZ Users
• W
AN Users
Unless your selection from the Action drop-down list is BLOCK always, you also need to
m
ake selections from the following drop-down lists:
• Select
Schedule
• QoS Priority
4. Click App
ly. The new rule is now added to the Outbound Services table. The rule is
automatically enabled.
Create DMZ WAN Inbound Service Rules
The Inbound Services table lists all existing rules for inbound traffic. If you have not defined
any rules, no rules are listed. By default, all inbound traffic (from the Internet to the DMZ) is
blocked.
Inbound rules that are configured on the LAN WAN Rules screen take precedence over
inbou
nd rules that are configured on the DMZ WAN Rules screen. As a result, if an inbound
packet matches an inbound rule on the LAN WAN Rules screen, it is not matched against the
inbound rules on the DMZ WAN Rules screen.