Filter
Top Products
IPv4 and IPv6 Internet and WAN Settings
31
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
You can set the failure detection method for each WAN interface on its corresponding
WAN Advanced Options screen (see Configure the Auto-Rollover Mode and Failure
Detection Method o
n page 44).
• Action. Th
e Edit table button provides access to the WAN IPv4 ISP Settings screen
(see Step 2) for the corresponding WAN interface; the Status button provides access
to the Connection Status screen (see Step 4) for the corresponding WAN interface.
2. Click the Edit
table button in the Action column of the WAN interface for which you want to
automatically configure the connection to the Internet. The WAN IPv4 ISP Settings screen
displays. (The following figure shows the WAN2 IPv4 ISP Settings screen as an example.)
Figure 12.
3. Click the Auto Detect button at the bottom of the screen. The autodetect process probes
the WAN port for a range of connection methods and suggests one that your ISP is most
likely to support.
The autodetect process returns one of the following results:
• I
f the autodetect process is successful, a status bar at the top of the screen displays
the results (for example, DHCP service detected).