Filter
Top Products
Virtual Private Networking Using IPSec and L2TP Connections
217
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
5. Click Apply to use the new settings immediately, and click Save to keep the settings for
future use.
6. Click the Advan
ced tab in the Authentication pane. The Advanced pane displays:
Figure 143.
7. Specify the settings that are explained in the following table.
Table 49. VPN client advanced authentication settings
Setting Description
Advanced features
Aggressive Mode Select this check box to enable aggressive mode as the mode of negotiation with
the VPN
firewall.
NAT-T Select Automatic from the
drop-down list to enable the VPN client and VPN
firewall to negotiate NAT-T.
Local and Remote ID
Local ID As the type of ID, select DNS fro
m the Local ID drop-down list because you
specified FQDN in the VPN firewall configuration.
As the value of the ID, enter rem
ote.com as the local ID for the VPN client.
Note: The remote ID on the VPN firewall is the
local ID on the VPN client. It might
be less confusing to configure an FQDN such as client.com as the remote ID on
the VPN firewall and then enter client.com as the local ID on the VPN client.