Filter
Top Products
LAN Configuration
89
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
Figure 50.
3. From the MAC Address for VLANs drop-down list, select Unique. (The default is Same.)
4. As an option,
you can disable the broadcast of ARP packets for the default VLAN by
clearing the Enable ARP Broadcast check box. (The broadcast of ARP packets is enabled
by default for the default VLAN.)
5. Click App
ly to save your settings.
Note: If you attempt to configure more than 16 VLANs while the MAC
address for VLANs is set to Unique on the IPv4 LAN Advanced
screen, the MAC addresses that are assigned to each VLAN might
no longer be distinct.
Note: For information about how to configure and enable the LAN traffic
meter, see
Configure and Enable the LAN Traffic Meter on
page 350.
Configure IPv4 Multihome LAN IP Addresses on the
Default VLAN
If you have computers using different IPv4 networks in the LAN (for example, 172.124.10.0 or
192.168.200.0), you can add aliases to the LAN ports and give computers on those networks
access to the Internet, but you can do so only for the default VLAN. The IP address that is
assigned as a secondary IP address needs to be unique and cannot be assigned to a VLAN.
Make sure that any secondary LAN addresses are different from the primary LAN, WAN, and
DMZ IP addresses and subnet addresses that are already configured on the VPN firewall.