Filter
Top Products
Monitor System Access and Performance
355
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
2. Enter the settings as explained in the following table:
Table 89. Firewall Logs & E-mail screen settings
Setting Description
Log Options
Log Identifier Enter the name of the log identifier. The identifier is appended to log messages to identify
the device that sent the log messages. The default identifier is SRX5308.
Routing Logs
In the Accepted Packets and Dropped Packets columns, se
lect check boxes to specify which traffic is
logged:
• LAN to WAN
• LAN to DMZ
• DMZ to WAN
• WAN to LAN
• DMZ to LAN
• WAN to DMZ
System Logs Option
Select the check boxes to specify
which system events are logged:
• Change of Time by NTP. Logs a message when the system time changes after a request from an NTP
server.
• Lo
gin Attempts. Logs a message when a login is attempted. Both successful and failed login attempts
are logged.
• Se
cure Login Attempts. Logs a message when a secure login is attempted. Both successful and failed
secure login attempts are logged.
• Re
boots. Logs a message when the VPN firewall has been rebooted through the web management
interface. (No message is logged when the factory default Reset button has been pressed.)
• Al
l Unicast Traffic. All incoming unicast packets are logged.
• Al
l Broadcast/Multicast Traffic. All incoming broadcast and multicast packets are logged.
• W
AN Status. WAN link status–related events are logged.
• Resolved DNS Names. All resolved DNS names are logged.
• VPN.
All VPN negotiation messages are logged.
Other Event Logs
Source MAC
Fil
ter
Select this check box to log packets from MAC addresses that match the source MAC
address filter settings.
Session Limit Select this check box to log packets that
are dropped because the session limit has been
exceeded.
Bandwidth
Limit
Select this check box to log packets that a
re dropped because the bandwidth limit has been
exceeded.