Filter
Top Products
Virtual Private Networking Using IPSec and L2TP Connections
218
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
8. Click Apply to use the new settings immediately, and click Save to keep the settings for
future use.
Create the IPSec Configuration (Phase 2 Settings)
Note: On the VPN firewall, the IPSec configuration (phase 2 settings) is
referred to as the IKE settings.
To create an IPSec configuration:
1. In the t
ree list pane of the Configuration Panel screen, right-click the vpn_client
authentication phase name, and then select New Phase 2.
2. Change
the name of the IPSec configuration (the default is Tunnel):
a. Right-click
the IPSec configuration name.
b. Select Rename.
c. Ty
pe netgear_platform.
d. Click anywhere in the tree
list pane.
Note: This is the name for the IPSec configuration that is used only for the
VPN client, no
t during IPSec negotiation. You can view and change this name
in the tree list pane. This name needs to be a unique name.
The IPSec pane displays in the Conf
iguration Panel screen, with the IPSec tab selected
by default:
Remote ID As the type of ID, select DNS from the Remote ID drop-down list because you
specified an FQDN in the VPN firewall configuration.
As the value of the ID, enter lo
cal.com as the remote ID for the VPN firewall.
Note: The local ID on the VPN firewall is the remote I
D on the VPN client. It might
be less confusing to configure an FQDN such as router.com as the local ID on the
VPN firewall and then enter router.com as the remote ID on the VPN client.
Table 49. VPN client advanced authentication settings (continued)
Setting Description