Filter
Top Products
Virtual Private Networking Using IPSec and L2TP Connections
233
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
Each policy contains the data that are explained in the following table. These fields are
explained in more detail in Table 55 on p
age 235.
To delete one or more VPN polices:
1. Select
the check box to the left of each policy that you want to delete, or click the Select
All table button to select all VPN policies.
2. Click the Del
ete table button.
To enable or disable one or more VPN policies:
1. Select
the check box to the left of each policy that you want to enable or disable, or click
the Select All table button to select all VPN Policies.
2. Click the Ena
ble or Disable table button.
For information about how to add or edit a VPN policy, see Manually Add or Edit a VPN
Policy on this page.
Manually Add or Edit a VPN Policy
To manually add a VPN policy:
1. Select VPN >
IPSec VPN > VPN Policies. The VPN Policies screen displays the IPV4
settings (see Figure 156 on p
age 232).
2. Unde
r the List of VPN Policies table, click the Add table button. The Add New VPN Policy
screen displays the IPv4 settings (see Figure 157 on p
age 234).
Table 54. VPN Policies screen information for IPv4 and IPv6
Item Description
! (Status) Indicates whether the policy is enabled (green ci
rcle) or disabled (gray circle). To enable
or disable a policy, select the check box to the left of the circle, and click the Enable or
Disable table button, as appropriate.
Name The name that identifies the VPN policy. When you use the
VPN Wizard to create a VPN
policy, the name of the VPN policy (and of the automatically created accompanying IKE
policy) is the connection name.
Type Auto or Manual as described previously (Auto
is used during VPN Wizard configuration).
Local IP address (either a single address, range of address, or subnet address) on your LAN.
Traffic needs to be from (or to) these addresses to be covered by this policy. (The subnet
address is supplied as the default IP address when you are using the VPN Wizard.)
Remote IP address or address range of the remote network. T
raffic needs to be to (or from) these
addresses to be covered by this policy. (The VPN Wizard default requires the remote
LAN IP address and subnet mask.)
Auth The authentication algorithm that is used for the VPN tun
nel. This setting needs to match
the setting on the remote endpoint.
Encr The encryption algorithm that is used for the VPN tunnel. This setting needs to match the
settin
g on the remote endpoint.