Filter
Top Products
Introduction
18
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
Table 1. LED descriptions
LED Activity Description
Power On (green) Power is supplied to the VPN firewall.
Off Power is not supplied to the VPN firewall.
Test On (amber) during
startup.
Test mode: The VPN firewall is initializing. After approximately 2 minutes,
when the VPN firewall has completed its initialization, the Test LED goes
off.
On (amber) during
any other time
The initialization has failed, or a hardware failure has occurred.
Blinking (amber) The VPN firewall is writing to flash memory (during upgrading or resetting
to defaults).
Off The system has booted successfully.
LAN Ports
Left LED On (green) The LAN port has detected a link with a connected Ethernet device.
Blinking (green) The LAN port receives or transmits data.
Off The LAN port has no link.
Right LED On (green) The LAN port operates at 1000 Mbps.
On (amber) The LAN port operates at 100 Mbps.
Off The LAN port operates at 10 Mbps.
DMZ LED On (green) Port 4 operates as a dedicated hardware DMZ port.
Off Port 4 operates as a normal LAN port.
WAN Ports
Left LED On (green) The WAN port has a valid connection with a device that provides an
Internet connection.
Blinking (green) The WAN port receives or transmits data.
Off The WAN port has no physical link, that is, no Ethernet cable is plugged
into the VPN firewall.
Right LED On (green) The WAN port operates at 1000 Mbps.
On (amber) The WAN port operates at 100 Mbps.
Off The WAN port operates at 10 Mbps.
Internet LED On (green) The WAN port has a valid Internet connection.
Off The WAN port is either not enabled or has no link to the Internet.