Filter
Top Products
Virtual Private Networking Using IPSec and L2TP Connections
204
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
To view the wizard default settings, click the VPN Wizard default values option arrow in
the upper right of the screen. A pop-up screen displays (see the following figure), showing
the wizard default values. The default values are the same for IPv4 and IPv6.
Figure 128.
3. Complete the settings as explained in the following table:
Table 44. IPSec VPN Wizard settings for an IPv6 gateway-to-gateway tunnel
Setting Description
About VPN Wizard
This VPN tunnel will connect
to th
e following peers
Select the Gateway radio button. The local WAN port’s IP address or
Internet name displays in the End Point Information section of the screen.
Connection Name and Remote IP Type
What is the new Connection
Na
me?
Enter a descriptive name for the connection. This name is used to help you
to manage the VPN settings; the name is not supplied to the remote VPN
endpoint.
This VPN tunnel will use the
foll
owing local WAN Interface
Select a WAN interface from the drop-down list to specify which local WAN
interface the VPN tunnel uses as the local endpoint.
Note: The Enable RollOver check box does not apply to an IPv6 tunnel
configuration.
What is the pre-shared key? Enter a pre-shared key. The key needs to be entered both here and on the
re
mote VPN gateway. This key needs to have a minimum length of
8 characters and should not exceed 49 characters.