NETGEAR SRX5308-100NAS Switch User Manual


 
Virtual Private Networking Using IPSec and L2TP Connections
244
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
Assign IPv4 Addresses to Remote Users (Mode Config)
Mode Config Operation
Configure Mode Config Operation on the VPN Firewall
Configure the ProSafe VPN Client for Mode Config Operation
T
est the Mode Config Connection
Modify or Delete a Mode Config Record
To simplify the process of connecting remote VPN client
s to the VPN firewall, use the Mode
Config feature to automatically assign IPv4 addresses to remote users, including a network
access IP address, subnet mask, WINS server, and DNS address. Remote users are given
IP addresses available in a secured network space so that remote users appear as seamless
extensions of the network.
You can use the Mode Config feature in combination with
an IPv6 IKE policy to assign IPv4
addresses to clients, but you cannot assign IPv6 addresses to clients.
Mode Config Operation
After the IKE Phase 1 negotiation is complete, the VPN connection initiator (which is the
remote user with a VPN client) requests the IP configuration settings such as the IP address,
subnet mask, WINS server, and DNS address from the VPN firewall. The Mode Config
feature allocates an IP address from the configured IP address pool and activates a
temporary IPSec policy, using the information that is specified in the Traffic Tunnel Security
Level section of the Mode Config record (on the Add Mode Config Record screen that is
shown in Figure 161 on
page 245).
Note: After configuring a Mode Config record, you need to manually
configure an IKE policy and select the newly created Mode Config
record from the Select Mode Config Record drop-down list (see
Configure Mode Config Operation on the VPN Firewall on
page 244). You do not need to change any VPN policy.
Note: An IP address that is allocated to a VPN client is released only after
the VPN client has gracefully disconnected or after the SA liftetime
for the connection has timed out.
Configure Mode Config Operation on the VPN Firewall
To configure Mode Config on the VPN firewall, first create a Mode Config record, and then
select the Mode Config record for an IKE policy.