Filter
Top Products
System Management: IPMI Messaging
KAT4000 User’s Manual 10007175-02
9-4
IPMI Completion Codes
All IPMI response messages contain a hexadecimal Completion Code field that indicates the
status of the operation.
Tab le 9 - 2 lists the Completion Codes (as defined in the IPMI specifi-
cation) used by the IPMC.
Table 9-2: Completion Codes
Code: Description:
Generic Completion Codes 00, C0-FF
00 Command completed normally
C0 Node busy–command could not be processed because command-processing
resources are temporarily unavailable
C1 Invalid command–indicates an unrecognized or unsupported command
C2 Command invalid for given LUN
C3 Time-out while processing command, response unavailable
C4 Out of space–command could not be completed because of a lack of storage space
required to execute the given command operation
C5 Reservation canceled or invalid Reservation ID
C6 Request data truncated
C7 Request data length invalid
C8 Request data field length limit exceeded
C9 Parameter out of range–one or more parameters in the data field of the Request are
out of range. This is different from Invalid data field code (CC) because it indicates that
the erroneous field(s) has a contiguous range of possible values.
CA Cannot return number of requested data bytes
CB Requested sensor, data, or record not present
CC Invalid data field in Request
CD Command illegal for specified sensor or record type
CE Command response could not be provided
CF Cannot execute duplicated request–for devices that cannot return the response
returned for the original instance of the request. These devices should provide separate
commands that allow the completion status of the original request to be determined.
An Event Receiver does not use this completion code, but returns the 00 completion
code in the response to (valid) duplicated requests.
D0 Command response could not be provided, SDR Repository in update mode
D1 Command response could not be provided, device in firmware update mode
D2 Command response could not be provided, Baseboard Management Controller (BMC)
initialization or initialization agent in progress
D3 Destination unavailable–cannot deliver request to selected destination. (This code can
be returned if a request message is targeted to SMS, but receive message queue
reception is disabled for the particular channel.)
D4 Cannot execute command, insufficient privilege level
D5 Cannot execute command, parameter(s) not supported in present state
FF Unspecified error