Filter
Top Products
Monitor: Other Commands
KAT4000 User’s Manual 10007175-02
14-22
um
The um command is a destructive memory test. Press the ‘q’ key to quit this test; the moni-
tor completes running the most recent iteration, and exits to the default prompt after dis-
playing cumulative results for the completed iterations.
Definition:
um [.b, .w, .l] base_addr [top_addr]
OTHER COMMANDS
This section describes all the remaining commands supported by the KAT4000 monitor.
autoscr
The autoscr command runs a script, starting at address addr, from memory.
A valid autoscr header must be present.
Definition:
autoscr [addr]
base
The base command prints or sets the address offset for memory commands.
Definition: Displays the address offset for the memory commands.
base
Sets the address offset for the memory commands to off.
base off
bdinfo
The bdinfo command displays the Board Information Structure.
Definition:
bdinfo
coninfo
The coninfo command displays the information for all available console devices.
Definition:
coninfo
crc32
The crc32 command computes a CRC32 checksum on count bytes starting at address.
Definition:
crc32 address count
date
The date command will set or get the date and time, and reset the RTC device.