Filter
Top Products
Setup: KAT4000 Setup
10007175-02 KAT4000 User’s Manual
2-15
KAT4000 SETUP
For step-by-step setup instructions, see the KAT4000 Quick Start Guide, #10008585-xx, or
the KAT4000 Quick Start Guide for the No-CPU Carrier Board, #10008506-xx.
You need the following items to set up and check the operation of the Emerson KAT4000:
❐ KAT4000 carrier
❐ ATCA chassis and power supply
❐ Compatible AMC modules
❐ Console serial cable(s)
❐ Optional rear transition module and cable
❐ CRT terminal
Save the antistatic bag and box for future shipping or storage.
Note: This guide assumes that the host is running Red Hat Linux 9.0. If you use a different Linux distribution, you’ll
have to adapt these instructions to your implementation.
Identification Numbers
Before you install the KAT4000 circuit board in a system, you should record the following
information:
❐ The board serial number: 711— _______________________________________ .
The board serial number appears on a bar code sticker located on the back of the board.
❐ The board product identification: _____________________________________ .
This sticker is located near the board serial number.
❐ The monitor version: _______________________________________________ .
The version number of the monitor is on the monitor start-up display.
❐ The operating system version and part number:__________________________ .
This information is labeled on the master media supplied by Emerson or another vendor.
❐ Any custom or user ROM installed, including version and serial number:
________________________________________________________________ .
It is useful to have these numbers available when you contact the Technical Support
department at Emerson.