Filter
Top Products
System Management: Vendor Commands
KAT4000 User’s Manual 10007175-02
9-16
Get Debug Level Command
The Get Debug Level command gets the current debug level of the IPMC firmware.
Table 9-10: Get Debug Level Command
Type: Byte: Data Field:
Request Data 1:3 PPS IANA Private Enterprise ID, MS Byte first
0x00400A = 16394 (Pigeon Point Systems)
Response Data 1 Completion Code
2:4 PPS IANA Private Enterprise ID, MS Byte first
0x00400A = 16394 (Pigeon Point Systems)
Response Data 5 Bits [7:5] Reserved
Bit [4] IPMB Dump Enable
If set to 1, the IPMC provides a trace of IPMB messages that
are arriving to/going from the IPMC via IPMB-O
Bit [3] Payload Logging Enable
If set to 1, the IPMC provides a trace of SIPL activity on the
Payload Interface onto the Serial Debug interface
Bit [2] Alert Logging Enable
If set to 1, the IPMC outputs important alert messages onto the
Serial Debug interface
Bit [1] Low-level Error Logging Enable
If set to 1, the IPMC outputs low-level error/diagnostic
messages onto the Serial Debug interface
Bit [0] Error Logging Enable
If set to 1, the IPMC outputs error/diagnostic messages onto
the Serial Debug interface