Filter
Top Products
System Management: Vendor Commands
10007175-02 KAT4000 User’s Manual
9-15
Set Serial Interface Properties Command
The Set Serial Interface Properties command is used to set the properties of a particular
serial interface.
Table 9-9: Set Serial Interface Properties Command
Response Data 1 Completion Code
2:4 PPS IANA Private Enterprise ID, MS Byte first
0x00400A = 16394 (Pigeon Point Systems)
5Bit [7] Echo On
If this bit is set, the IPMC enables echo for the given serial
interface
Bits [6:4] Reserved
Bits [3:0] Baud Rate ID
The baud rate ID defines the interface baud rate as follows:
0 9600 bps
1 19200 bps
2 38400 bps
3 57600 bps (unsupported)
4 115200 bps (unsupported)
Type: Byte: Data Field:
Request Data 1:3 PPS IANA Private Enterprise ID, MS Byte first
0x00400A = 16394 (Pigeon Point Systems)
4Interface ID
0Serial Debug Interface
1 Payload Interface
5Bit [7] Echo On
If this bit is set, the IPMC enables echo for the given serial
interface
Bits [6:4] Reserved
Bits [3:0] Baud Rate ID
The baud rate ID defines the interface baud rate as follows:
0 9600 bps
1 19200 bps
2 38400 bps
3 57600 bps (unsupported)
4 115200 bps (unsupported)
Response Data 1 Completion Code
2:4 PPS IANA Private Enterprise ID, MS Byte first
0x00400A = 16394 (Pigeon Point Systems)
Type: Byte: Data Field: (continued)