Filter
Top Products
Setup: KAT4000 Circuit Board
10007175-02 KAT4000 User’s Manual
2-13
Reset
The reset signals are routed to the PLD. See Chapter 7 for the reset registers. The following
sources can reset the KAT4000:
Front Panel: The front panel reset switch can reset the board.
Remote IPMI: The KAT4000 is capable of being reset remotely via the IPMI controller.
Software: Software is capable of asserting reset to the individual modules (see “reset” on
page 14-25).
Processor: The processor is also capable of resetting the board.
RTM: If a rear transition module is used that utilizes the Zone 3 reset signal, the board can be
reset from the RTM.