Filter
Top Products
System Management: IPMC Watchdog Timer Commands
KAT4000 User’s Manual 10007175-02
9-30
Table 9-32: Set Watchdog Timer Command
Type: Byte: Data Field:
Request Data 1 Timer Use
[7] 1b=don’t log
[6] 1b=don’t stop timer on Set Watchdog Timer command (new
for IPMI v1.5) new parameters take effect immediately. If
timer is already running, countdown value will get set to
given value and countdown will continue from that point.
If timer is already stopped, it will remain stopped. If the
pretime-out interrupt bit is set, it will get cleared.
1
0b=timer stops automatically when Set Watchdog Timer
command is received
[5:3] reserved
[2:0] timer use (logged on expiration when “don’t log” bit = 0b)
000b=reserved
001b=Monitor FRB-2
010b=Monitor/POST
011b=OS Load
100b=SMS/OS
101b=OEM
110b-111b=reserved
2Timer Actions
[7] reserved
[6:4] pretime-out interrupt (logged on expiration when “don’t
log” bit = 0b)
000b=none
001b=SMI
010b=NMI/Diagnostic Interrupt
011b=Messaging Interrupt (this is the same interrupt as
allocated to the messaging interface)
100b, 111b =reserved
[3] reserved
[2:0] time-out action
000b=no action
001b=Hard Reset
010b=Power Down
011b=Power Cycle
100b, 111b=reserved
3 Pretime-out interval in seconds, ‘1’ based