Filter
Top Products
Appendix A: Serial Command Line Interface (CLI)
10007175-02 KAT4000 User’s Manual
A-3
• Mirror: Mirroring is disabled.
• IP: IP mode is disabled and no IP address/mask/gateway is configured. To enable the
web interface, an IP address must be configured.
SERIAL COMMAND LINE INTERFACE (CLI)
Through the serial-based switch configuration, you have all the configuration options
found in the web application and more. The command line offers the option of configuring
the devices directly, without having to create a separate VLAN just for the web configura-
tion. The direct serial method allows for the board to be fully configured without using a
dedicated Ethernet port for configuration. General CLI usage instructions and command
details are described below.
Log In/Log Out Procedures
1 To get access to the CLI, log in when prompted. No password is required.
2 Logout at any time and at any context level using the exit command.
Help Utility
Access help by pressing the ? key or entering help. The help info depends on the context:
• At top level, a list of command groups is displayed.
• At group level, a list of the command syntaxes for the current group is displayed.
• If the help command is issued for a specific command, the command syntax and a
description of the command are shown.
The command hierarchy and the help utility are demonstrated in the following example:
> ? <enter>
Commands at top level:
System – System commands
Console – Console commands
Port – Port commands
MAC - MAC table commands
VLAN – VLAN commands
Aggregation – Aggregation/Trunking commands
User Group – User Group commands
QoS – QoS commands
Mirror – Mirror commands
IP – IP commands
Debug - Debug commands
> console <enter>
Console> ? <enter>
Commands at Console level:
Console Configuration
Console Password [<password>]
Console Timeout [<timeout>]