Filter
Top Products
System Management: Vendor Commands
KAT4000 User’s Manual 10007175-02
9-18
Set Hardware Address Command
The Set Hardware Address command allows overriding of the hardware address read from
hardware when the IPMC operates in (Manual) Standalone mode.
Table 9-13: Set Hardware Address Command
Get Handle Switch Command
The Get Handle Switch command reads the state of the Hot Swap handle of the IPMC. Over-
riding of the handle switch state is allowed only if the IPMC operates in (Manual) Standalone
mode.
Table 9-14: Get Handle Switch Command
Type: Byte: Data Field:
Request Data 1:3 PPS IANA Private Enterprise ID, MS Byte first
0x00400A = 16394 (Pigeon Point Systems)
4 Hardware Address
If set to 00, the ability to override the hardware address is
disabled
NOTE: A hardware address change only takes effect after an
IPMC reset. See “Reset IPMC Command” on page 9-21.
Response Data 1 Completion Code
2:4 PPS IANA Private Enterprise ID, MS Byte first
0x00400A = 16394 (Pigeon Point Systems)
Type: Byte: Data Field:
Request Data 1:3 PPS IANA Private Enterprise ID, MS Byte first
0x00400A = 16394 (Pigeon Point Systems)
Response Data 1 Completion Code
2:4 PPS IANA Private Enterprise ID, MS Byte first
0x00400A = 16394 (Pigeon Point Systems)
5 Handle Switch Status
0x00 The handle switch is open
0x01 The handle switch is closed
0x02 The handle switch state is read from hardware