Filter
Top Products
Monitor: IPMC Commands
KAT4000 User’s Manual 10007175-02
14-18
imw
The imw command writes (fills) memory.
Definition:
imw chip address[.0, .1, .2] value [count]
inm
The inm command modifies I
2
C memory, reads it, and keeps the address.
Definition:
inm chip address[.0, .1, .2]
iprobe
The iprobe command probes to discover valid primary I
2
C bus chip addresses.
Definition:
iprobe
iprobe2
The iprobe command probes to discover valid secondary I
2
C bus chip addresses.
Definition:
iprobe2
switchsrom
The switchsrom command reads bytes from the VSC7376 GbE switch EEPROM and writes
bytes to the EEPROM.
Definition:
switchsrom read <offset> <size>
switchsrom write <source address> <size>
IPMC COMMANDS
IPMI Baseboard Management Controller (BMC) watchdog is supported and serviced
throughout the monitor boot process. The BMC watchdog is disabled if the monitor goes to
the monitor prompt.
fru
The fru command opens, closes, saves, sets, shows, dumps, and loads fru data to and from
the IPMC.
Definition:
fru <command> [ arg1 arg2 … ]
command := [ open | close | save | set | show | dump | load | create ]
fru open <id>
fru close
fru save
fru set <section [chassis|board|product]><field><value>
fru set <section> <field> <value>
section := [ chassis | board | product ]